ThermaCELL Camping Lantern

1. Remove one ThermaCELL® Mosquito Repellent mat from wrapper.
2. With globe in the OFF position, insert the mat under the grill at the top of the lantern.

3. Remove the butane cartridge cap and screw the cartridge into the opening of the lantern base by turning the cartridge clockwise until it stops. Make sure the cartridge is fully inserted.

4. Place the lantern on a flat stable area. Rotate the globe clockwise to the maximum setting. The gas will begin to flow.
5. Wait approximately 5 to 10 seconds then depress the start button three to five times in rapid succession.
6. Verify the lantern is operating (lantern will glow). If the lantern fails to glow, check to make sure the lantern is turned on and the cartridge is fully inserted. Also check the cartridge's fuel level. If the fuel level in the cartridge is empty, turn lantern off and replace the cartridge, repeating steps 3 through 6.
7. Adjust the lantern by turning the globe.
8. When finished using the lantern, rotate the globe to the OFF position. Allow the lantern to completely cool before storing.
9. To replace a used mat, turn off lantern and allow to completely cool. Push the used mat out by inserting a fresh mat.